How to keep the surface brightness of round hole mesh

Round hole mesh is a kind of metal mesh structure element used for screening and filtering. It is used in screening, filtration, dehydration, desliming and other operations in many industries. It has very high strength, steel and bearing capacity, can be made into a variety of shapes of steel screening filter device.
So how should we keep the surface brightness of the circular hole mesh?
Round hole mesh in packaging, it is important to control the temperature and humidity, so the humidity of the wood shaft and the box plate should be small, and the temperature of the aluminum coil should be small.
If the round-hole mesh is transported from the low-temperature area to the area with high temperature and humidity, do not immediately open the sealed package. To let the sieve plate can have time to adapt to these environments, workshop, warehouse roof leakage, snow, should not be placed aluminum coil.
Strengthen the management of rolling oil, its water content is controlled below 0.04%. The packaging of aluminum foil rolls should be sealed, and each roll should be put into an appropriate amount of desiccant. Reduce the surface of the sieve plate contact with air and water.
Strengthen the management of air drying, compressed air without water.
In order to avoid the occurrence of scratches, the aluminum plate is covered with a thin layer of plastic film during processing.
Only punching net manufacturers in the case of equipment improvement will have a good punching net quality, then in the case of equipment improvement will have what kind of product quality? Create will be in the punching above to meet more color requirements, it is necessary to let users pay attention to, different users will be for this product punching pattern will be very different, some users only need ordinary punching can, but there are some users will have special requirements, it has what kind of pattern in punching, naturally depends on the equipment.
Only when the equipment of the punching net is improved, it will really meet the requirements of all users, so this is the first quality of the equipment to improve, and then is to improve the punching process above, if it is a manufacturer in the production of no better process, it will reduce the quality because of rough, but it also needs to let users pay attention to in this respect, generally speaking, Large manufacturers will improve the product process, naturally because they are superior to other manufacturers in equipment.